Record on Standard Windows Controls during an SAP GUI for Windows recording session

To enable UFT to record steps on standard Windows controls during an SAP GUI for Windows recording session, you must switch to Standard Windows Recording mode prior to performing steps on these controls. (If you switch to Standard Windows Recording mode after performing an operation on a standard Windows control, both UFT and the SAP application may sometimes become unresponsive.)

Switch to Standard Windows recording mode while recording a test in an SAP GUI for Windows application:

On the Record toolbar, select Standard Windows Recording from the Recording Modes drop-down.

To record steps as SAP GUI for Windows objects again:

Do one of the following:

  • On the Record toolbar, select Default from the Recording Modes drop-down.
  • Stop the recording session.

This restores the normal recording mode for SAP GUI for Windows.